C50 engine RPM info.
Welcome guest, is this your first visit? Create Account now to join.

Welcome to the Motorcycle Forum.

Register ButtonIf this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Page 1 of 3 123 LastLast
Results 1 to 15 of 39
  1. #1
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709

    C50 engine RPM info.

    Can someone tell me what RPMs at 40, 50, and 60 MPH a C50 has at those speeds. It seems that that my new tach is indicating low RPMs, but then I read that the C50 engine is a low reving engine. Thanks.

    HAPPY NEW YEAR TO ALL.

  2. Remove Advertisements
    MotorcycleForums.net
    Advertisements
     

  3. #2
    Sit speling cheker
    Posts
    1,607
    Quote Originally Posted by Sgt Mike
    Can someone tell me what RPMs at 40, 50, and 60 MPH a C50 has at those speeds. It seems that that my new tach is indicating low RPMs, but then I read that the C50 engine is a low reving engine. Thanks.

    HAPPY NEW YEAR TO ALL.
    What type of tach and did you install a double fire ignition adapter to the tach ?

    At 60 in fifth you should be turning close to 4 K.

  4. #3
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    Thanks for the reply Dan.
    I have a DRAG SPECIALTIES MINI ELECTRONIC TACHOMETER - BLACK FACE #PUDS244133.
    Do I need a double fire adaptor? Some say I need it and some say I don't. At 60 MPH in fith gear I'm not turning close to 4K. So it looks like an adaptor is most likely required. You recommended that on another thread, I should've listened.



    Quote Originally Posted by Danr
    What type of tach and did you install a double fire ignition adapter to the tach ?

    At 60 in fifth you should be turning close to 4 K.

  5. Remove Advertisements
    MotorcycleForums.net
    Advertisements
     

  6. #4
    Sit speling cheker
    Posts
    1,607
    I bet your turning somewhere around 2 K ? If so you need the adapter.

  7. #5
    Sprocket Pilot
    My Bike(s)
    Suzuki LC 1500 and 2005 Honda VTX1300
    Location
    Tiverton RI
    Posts
    851
    Most of what I read adapters are for single fire bikes that need a one. Didn't you runa ground to both coils.
    Back in the saddle again

  8. #6
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    I think that's about right. I'll get one tomorrow from my dealer.


    Quote Originally Posted by Danr
    I bet your turning somewhere around 2 K ? If so you need the adapter.

  9. #7
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    I'm not quite sure what you're trying to tell me Carlos. Can you elaborate? I mounted the tach but had my dealer wire it, my son got me a gift certificate to get it wired. The front and rear cylinders are not firing at the same time are they? What would running a ground to both coils accomplish?


    Quote Originally Posted by 4dtvman
    Most of what I read adapters are for single fire bikes that need a one. Didn't you runa ground to both coils.
    Last edited by Sgt Mike; 01-01-2007 at 08:34 PM.

  10. #8
    Sprocket Pilot
    My Bike(s)
    Suzuki LC 1500 and 2005 Honda VTX1300
    Location
    Tiverton RI
    Posts
    851
    You see I'm ordering one for my bike and I've done alot of reading and the more I read the worst it gets. But all that I've read is that suzuki's are double fired.What does the tach say when it at idle, should be around 1000 RPM's.

    Read number 4 on these thread.

    http://www.motorcycle-journal.com/fo...ht=single+fire
    Back in the saddle again

  11. #9
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    At idle my tach indicates about 500 to 600 RPMs.

    Quote Originally Posted by 4dtvman
    You see I'm ordering one for my bike and I've done alot of reading and the more I read the worst it gets. But all that I've read is that suzuki's are double fired.What does the tach say when it at idle, should be around 1000 RPM's.

    Read number 4 on these thread.

    http://www.motorcycle-journal.com/fo...ht=single+fire

  12. #10
    Sprocket Pilot
    My Bike(s)
    Suzuki LC 1500 and 2005 Honda VTX1300
    Location
    Tiverton RI
    Posts
    851
    did you install it or the dealer did
    Back in the saddle again

  13. #11

    Posts
    32
    Have a look over here & add these to the boxes>>

    Primary Reduction Ratio - 1.690

    1st Gear - 2.461

    2nd Gear - 1.631

    3rd Gear - 1.227

    4th Gear - 1.000

    5th Gear - 0.814

    Final Drive Reduction - 3.503

    Tire Diameter - 26.0

    Engine Redline - 7800

  14. #12
    Sprocket Pilot
    My Bike(s)
    Suzuki LC 1500 and 2005 Honda VTX1300
    Location
    Tiverton RI
    Posts
    851
    Thanks for the chart.

    Well Sgt Mike at 60 mph your tach should read 3738 RPM's are you any were close. I enclosed that chart with you bikes input from our friend gave us by Hipster Doofus
    Back in the saddle again

  15. #13
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    I had the dealer wire it.

    Quote Originally Posted by 4dtvman
    did you install it or the dealer did

  16. #14
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    Thanks Hipster, this is great.

    Quote Originally Posted by Hipster Doofus
    Have a look over here & add these to the boxes>>

    Primary Reduction Ratio - 1.690

    1st Gear - 2.461

    2nd Gear - 1.631

    3rd Gear - 1.227

    4th Gear - 1.000

    5th Gear - 0.814

    Final Drive Reduction - 3.503

    Tire Diameter - 26.0

    Engine Redline - 7800

  17. #15
    Banned
    My Bike(s)
    2006 Suzuki C50
    Location
    Hagerstown, Maryland
    Posts
    709
    Thanks for filling out the boxes Carlos. I'll have to check the RPMs, propably tomorrow, I'll keep you posted.


    Quote Originally Posted by 4dtvman
    Thanks for the chart.

    Well Sgt Mike at 60 mph your tach should read 3738 RPM's are you any were close. I enclosed that chart with your bike's input from our friend gave us by Hipster Doofus


 
Page 1 of 3 123 LastLast

Sponsored Links

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Similar Threads

  1. 1991 GSXF600 Engine Anyone Know Ignition INFO.
    By CoconutColin in forum Mechanics Corner
    Replies: 1
    Last Post: 12-22-2005, 12:55 AM
  2. need fi info
    By aguyintx66 in forum Marauder M50 Secret Hideaway
    Replies: 3
    Last Post: 07-06-2005, 01:10 AM
  3. Info on S40
    By JOSPDX1 in forum Cruisers
    Replies: 7
    Last Post: 05-18-2005, 08:29 PM
  4. I need Info. !!!
    By bluedevil127 in forum The Paddock
    Replies: 8
    Last Post: 04-29-2004, 07:23 AM
  5. GSXR'92 engine swap - info needed
    By ppereira in forum Mechanics Corner
    Replies: 9
    Last Post: 03-17-2004, 12:29 PM

Search tags for this page

2006 suzuki c50 rpm at 60 mph
,

c50 engine rpm at 65mph

,

c50 rpm

,

c50 rpm chart

,
rpms at 60 mph on suzuki c50
,
suzuki c50 revs
,

suzuki c50 rpm

,

suzuki c50 rpm @ 60 mph

,

suzuki c50 rpm at 60

,
what idle rpm c50 boulevard 2007
Click on a term to search for related topics.