04' Busa - install a yoshi 4-in1

1222 Views 7 Replies 4 Participants Last post by The Chad, Jan 14, 2005

ematheus

Discussion Starter · Jan 5, 2005

Hi there:
I finally decided to get a yosimura 4 in 1 for my Busa and I would like to install it myself. I was wondering if anybody out there has experience and could give me some advice. I did some small work on bikes before and I'm confident about the exhaust. I just have no experience with fairings....
You input is appreciated!!
:roll: :roll:

Save

1 - 1 of 8 Posts

Busafied00

· #4 · Jan 5, 2005

from 3-15hp, depending on mapping etc.

Don't forget to remove the Pair Valve Setup, and BLOCK the holes above the Exhaust ports.
Buy the block-off plates, or cut the tubes and crimp them shut, then roll them over.

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.