Motorcycle Forum banner

Fitting windscreen to rider

1880 Views 12 Replies 7 Participants Last post by  bat4255
Hello everyone,

Being a new rider, I finally gathered enough courage couple weekends ago, to get on the Los Angeles Freeways. All went well yet I was a little uncomfortable with wind resistance without a shield on my new C50. So last weekend I dished out the 300 some $s and got the C50 OEM windshield, in the hope it will make future freeway riding somewhat more comfortable.

After trying it out I noticed that there is more wind turbulence around my helmet area which seemed bothersome. The windshield adjusts up/down by about an inch, and I tried both positions. In the low position, I am looking over the windshield but with more helmet air turbulence. In the high position, I am looking mostly through it with less turbulence (turbulence not completely gone) but have to slouch a little.

I read a couple threads on this forum that seemed to suggest that the proper rider position is to look over the screen, not through it. Also, that having "lowers" installed may help reduce helmet turbulence.

I would greatly appreciate any feedback on:
- what is the proper riding position with respect to the windshield (look over it or through it)?
- is more turbulence expected or did I get the wrong windshield for my height (I am 6'1)?
- Do lowers (or anything else for that matter) really help with the helmet air turbulence?

One final thought, I don't mind the air itself since most of the time it's hot here and you get more of a cooling effect that way, but I cant stand the noise and the vibrations.
See less See more
1 - 2 of 13 Posts
bat4255 said:
There isn't any on the Burgman either. However I did manage to shim under the the top mounting bracket, and, under the top holes under the windshield, (to push it out a bit) using rubber hose washers. You may be able to use some stainless steel washers to do the same. It may only take an 1/8" - 1/4" to do the job.
Thanks for the suggestion. Definetly worth a try. Although getting to the bracket on the OEM installation is such a pain. Have to remove the turn signals and headlight cover. Having installed it myself, at least now I know how. I will try it.

If that doesn't work, do you think I should even consider shortening the windshield by cutting it? How does one cut a windshield?
1 - 2 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.