Intruder 800: Stalls, Restarts Occasionally

3515 Views 6 Replies 5 Participants Last post by dirtyfingers, May 17, 2005

KBrodock

Discussion Starter · May 5, 2005

I've got a 1995 Intruder 800 with two problems: it stalls and it then doesn't restart for a while. Here's the scenario:

Riding along, when I'm slowing to a stop, I'll pull the clutch in while braking and sometimes it stalls. When I go to restart it, the lights are on, but when I press the starter button, nothing happens. Nothing. So I usually turn it off and on a few times, work the clutch a bit and then randomly, it'll start and off I go again... 'til the next stop light.

Can anyone help me troubleshoot these two problems? I'm picking up a wiring diagram tomorrow because it seems to me that this has got to be electrical in nature. If so, are there any areas I should concentrate on first?

I appreciate any help. This hasn't been a good week for vehicles.... my car blew a seal (or something) in the cam.

-Keith

Save

1 - 2 of 7 Posts

KBrodock

Discussion Starter · #5 · May 5, 2005

I don't think it's the kickstand switch only because I would expect it to stall when I hit hard bumps too. I don't get why it would stall only when pulling in the clutch when slowing. If it were a loose connection (and I'm not ruling that out), I would think that any bumps would cause the problem too.... or perhaps because I'm at speed, the bike continues to turn over and I don't notice it??

Keep the ideas coming.....

-Keith

Save

1 - 2 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month