Motorcycle Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have just replaced all of the clutch plates and steels and my clutch still will not disengauge. It does bleed just fine. The clutch lever is very hard to pull and just doesn't seem to be working. If not the plates, what could this be? Thanks
 

·
Super Moderator
Joined
·
13,709 Posts
I have just replaced all of the clutch plates and steels and my clutch still will not disengauge. It does bleed just fine. The clutch lever is very hard to pull and just doesn't seem to be working. If not the plates, what could this be? Thanks
Master cylinder or line blockage.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Well I took apart the master cyclinder and everything seemed okay, and the line bleeds fine, so I didn't think that could be the problem. I did notice that the springs were flipping over on themselves after a couple pulls on the clutch, so I have ordered new ones. Hopefully that will be the answer.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top