square peg, round hole?

1797 Views 10 Replies 8 Participants Last post by arnie1313, Apr 12, 2004

arnie1313

Discussion Starter · Mar 27, 2004

i am trying to fit a gsxr 1100 (only a couple of years old) water cooled engine into a D reg gsxr 750 frame, the problem is i can get the rear lower mounting bolt (12mm) all fitted but nothing else seems to lin up and the back of the engine is touching the front of the swinging arm! Can anyone advise?

Save

1 - 1 of 11 Posts

Irwin

· #5 · Apr 1, 2004

Dear Burnagoodone,

That scenerio of letting the highschool shop class remount a motor into your bike sounds scary as a Hydrogen Balloon. Not knowing the stress points on the frame, etc. I wish you luck and if you ever ride it, please be careful. It just sounds like something you might hear about in the Darwin Awards.

Save

1 - 1 of 11 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.