Motorcycle Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I changed the friction/clutch plates in my 1999 vstar 1100 custom. Took my time thought I got it all back together correctly. Went to try it out to see how it worked, fired right up and now it does not go into gear when I push up or down on shifter. Neutral light goes off but when I let clutch out it does nothing. Any help greatly appreciated. I'm new to this so I'm stumped. I did soak plates before installing, the clutch plates were installed with "flat"side out. Any suggestions. Hoping I dont have to take apart again.
 

·
Super Moderator
Joined
·
12,237 Posts
Please post your questions in only ONE sub-forum here so the discussion can be kept together.
Since the other one you started already has a reply, I will be closing this one.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top